Specific Steps For Winch Dragging

The specific steps for dragging with a winch are:
1. Check the drum first. Before starting, make sure that the rope is neatly wound around the drum.
2. If the noose comes out, it should be prevented from swinging back and forth. If the noose breaks, the rope swinging back and forth can be very dangerous. However, it can be avoided by simply placing a cushion on the tight rope.
3. Start dragging. If you are using a noose to pull your car and you are driving on it, it is best to have someone outside to help you. The driver can operate the winch on the vehicle according to the instructions of the external commander.
4. If the noose is twisted together, be sure to pull it apart. When the rope is wound around the drum, it is easy to cross or become uneven on one side. Therefore, it is important to pay close attention to its state.
5. When the car can walk freely, towing is completed. Once you return to the level ground, check the condition of the vehicle and lines. If the car can be driven without external force, the process of using a winch to drag is over.
6. Roll up the noose. Tighten the noose and carefully send it back. If the rope is crossed or twisted on the drum, it must be completely untied before being rewound.
7. Finally, place the hook. When there is only the last bit of the rope left, tie the hook to the side of the winch. Then roll up the remaining bit of the rope and press the hook down.
8. Remove the remote control.